Ok... I'm having some mild success with multiple breakups.. This test is with a larger more dense cube. I found that the glue strength parameters needed to be majorly tweaked to get a result. This time I've referenced the colour values in the 'Glue Impulse' parameter in the RDB State.. The 'Glue Impulse' is:
"The amount of force that has accumulated on this object so far. You can set this value explicitly. This can be used to reset glue impulses at certain times, or to force the breaking of the object."
I inputted the following:
point("..:block_`$OBJID-5`/Geometry",0,"break",0)*5000
This basically give's a difference in impulse according to the colour. And the *5000 is used as a multiplier to make the colour values further apart.
Check the test out anyways.. you can see more of a multiple break-up as the cubes hit both steps and then the floor..
Subscribe to:
Post Comments (Atom)
No comments:
Post a Comment